Running Debian on ASUS WL-500G deluxe:Additional hardware
Go back to the main "Running Debian on ASUS..." page.
Philips pwc webcams
WL-500gP works with Philips webcams using pwc module.
I did transcode a live stream using vlc and it worked fine.
So far, it is not possible to use Broadcom mini-PCI. I tried two alternatives, one of which worked:
prism2_usb USB wireless card
USB wireless cards using prism2_usb module seem to work fine.
My card was identified by lsusb as:
# lsusb (...) Bus 002 Device 002: ID 0967:0204 Acer (??) WarpLink 802.11b Adapter
Note that the prism2_usb is not in the mainline Linux kernel and some additional compilation is needed - see http://www.linux-wlan.org.
I couldn't make this mini-PCI card work with ASUS WL-500gP:
# lspci -vv -nn 00:02.0 Network controller : Intersil Corporation ISL3890 [Prism GT/Prism Duette]/ISL3886 [Prism Javelin/Prism Xbow] [1260:3890] (rev 01) Subsystem: Intersil Corporation Unknown device [1260:0000] Control: I/O- Mem+ BusMaster+ SpecCycle- MemWINV+ VGASnoop- ParErr- Stepping- SERR- FastB2B- Status: Cap+ 66MHz- UDF- FastB2B+ ParErr- DEVSEL=medium >TAbort- <TAbort- <MAbort- >SERR- <PERR- Latency: 80 (2500ns min, 7000ns max), Cache Line Size: 32 bytes Interrupt: pin A routed to IRQ 6 Region 0: Memory at 40004000 (32-bit, non-prefetchable) [size=8K] Capabilities: [dc] Power Management version 1 Flags: PMEClk- DSI- D1+ D2+ AuxCurrent=0mA PME(D0+,D1+,D2+,D3hot+,D3cold+) Status: D0 PME-Enable- DSel=0 DScale=0 PME-
The card throws "Your card/socket may be faulty, or IRQ line too busy" error.
See also this thread on linux-wireless list for more info:
USB ADSL modems
Sagem F@st is a USB ADSL modem. It doesn't need any external power source - it is enough to plug its USB cable to your ASUS router.
This USB ADSL modem is very popular in Poland with Neostrada ADSL from Telekomunikacja Polska ISP and is confirmed to work there.
I couldn't make it work in Germany with ADSL from Netcologne.